The Music System from Processor Technology



The "Music System" from Software Technology (a division of Processor Technology) was an innovative and low cost system for generating music on early personal computers. The Music System was designed primarily for the Sol-20 computer (or systems running "Sub-System B" from Processor Technology).

The package consisted of software for authoring and playing music along with a simple S-100 board requiring just three components. Despite the simple hardware, the system could play three voice (part) music.

The Music System can be run on machines other than those from Processor Technology by providing a monitor ROM that provides the same console I/O entry points as the SOLOS or CUTER ROMs from Processor Technology. The video to the right demonstrates the Music System running on a real Altair 8800.

Running on an Altair 8800 Clone


Even though the Music System requires additional hardware in order to run, the equivalent hardware can be easily constructed and connected to an Altair 8800 Clone. The video on the right demonstrates the Music System running on an Altair 8800 Clone computer.

Building Your Own

As an introduction, be sure to watch the two videos on this page.

Click here to download the user's manual for the Music System. The schematic for hardware required is on page 7. For line level output, only R1, C1, and C2 are required.

The CUTER monitor, ported to the Altair, along with the Music System software and songs, are available here.

The following pictures show the Music System board installed in the Altair Clone. Click on any picture for a bigger version.

The green wire is attached to ground, the blue wire picks up the INTE signal from the Clone PCB. Note that solder connections can be made from the same side as the wire inserts by leaving a bit of exposed wire above the surface of the PCB to which the solder can adhere.

installed board wiring