I have TURMON at location FD00 in ROM on the FDC+
I can examine FD00 and execute it fine manually and get a dot prompt.
I'm trying to set VDIP #2 to FD so when I power up, the computer will execute TURMON.
When I set the FP VDIP #2 to FD (the MSB of the Power-On Jump Address), though, all I get on the terminal is a weird ASCII character (it varies)
and not the dot prompt. I can't type anything.
I have VDIP #1 set to 01100000 to turn on the FF Latch and Code Injection but when I set the MSB of the Power-On jump Address in FDIP #2 and save it, bit 7 (Pwr Reset) of VDIP #1 is automatically set. Is that supposed to happen?
In any case, should I be able to run TURMON at power-up? If so, how?