When I first turn on the 8800c, all the data lights and the INTE light are on. All other lights are off.
If I do a STOP-RESET, The INTE light goes out, the WAIT light comes on, the PROT light stays off and all the status lights come on.
They don't change as a program runs, either. That's not normal.
On the Clone, MEMR, MI, and WO are on and all other status lights are off after a hard reset.
I can examine and deposit memory locations properly (as well as examine next and deposit next)
I have the FDC+ board with the monitor disabled, RAM enabled, and I'm using PINT.
Any ideas on what to check?