Altair 8800 Clone Firmware Version 1.6

Announcements about the Altair 8800 Clone including software and hardware updates.

Altair 8800 Clone Firmware Version 1.6

Postby AltairClone » March 12th, 2014, 10:14 pm

Firmware version 1.6 for the Altair Clone is now available on the support page.

While working on a project unrelated to the Altair Clone, I discovered that the 2SIO board forces a single 500us wait cycle on the 8080 processor during input operations. I've read the 2SIO manual 100 times, but just now noticed this fact! Altair Clone firmware version 1.6 incorporates this wait state in the 2SIO emulation. The other hardware devices emulated in the Clone do not generate a wait state.

One effect of this wait state is a dim, but obvious glow in the WAIT LED on the front panel whenever the processor is polling the 2SIO status register while waiting for input. So we now have one more blinking light to watch on the front panel while the computer runs!

Mike
AltairClone
Site Admin
 
Posts: 291
Joined: April 5th, 2013, 10:55 am

Return to Announcements

Who is online

Users browsing this forum: No registered users and 1 guest

cron