AltairClone wrote:Tom, do you have a Teletype? How do you presently have the current loop interface wired? Do you have it terminate in a male DB-25 with pins 2-5 wired as recommended by MITS?
Mike
AltairClone wrote:Sure! Put this inside the Clone instead of inside the Teletype :)
http://altairclone.com/teletype.htm
Mike
AltairClone wrote:Regarding an RS-232 interface for the Teletype: How about an "authentic" looking board that fits inside the UCC and has a single connection to the P2 connector on the back of the UCC through which the board obtains power and the transmit/receive current loop signals? No wire cutting, AC adapters, etc. required. RS-232 connection to the board could be through a DB25 connector on the board, or maybe to be a bit more authentic, a three position terminal block?
Mike
Users browsing this forum: No registered users and 29 guests