Page 1 of 1

Parallel Port Possible?

PostPosted: July 6th, 2018, 3:04 pm
by toml_12953
Would it be possible to update the Clone's firmware to let one of the serial ports to act like a parallel port? The OP paper tape reader looks cool even though I already have a high-speed reader/punch unit thanks to one of your earlier videos, Mike.

Re: Parallel Port Possible?

PostPosted: July 6th, 2018, 8:44 pm
by AltairClone
The Clone already supports two of the common Altair parallel ports through a Clone serial port: The output and status port on the 88-LPC and the output and status port on the 88-C700. Similarly, it would not be difficult to “act like” the 88-PIO parallel interface board as well. However, electrically, it would still be a serial port, not a parallel port. It could not properly interface to a parallel device like the OP-80A paper tape reader.

Mike