Parallel Port Possible?

General discussions related to the Altair 8800 Clone

Parallel Port Possible?

Postby toml_12953 » July 6th, 2018, 3:04 pm

Would it be possible to update the Clone's firmware to let one of the serial ports to act like a parallel port? The OP paper tape reader looks cool even though I already have a high-speed reader/punch unit thanks to one of your earlier videos, Mike.
toml_12953
 
Posts: 134
Joined: June 7th, 2013, 12:54 pm

Re: Parallel Port Possible?

Postby AltairClone » July 6th, 2018, 8:44 pm

The Clone already supports two of the common Altair parallel ports through a Clone serial port: The output and status port on the 88-LPC and the output and status port on the 88-C700. Similarly, it would not be difficult to “act like” the 88-PIO parallel interface board as well. However, electrically, it would still be a serial port, not a parallel port. It could not properly interface to a parallel device like the OP-80A paper tape reader.

Mike
AltairClone
Site Admin
 
Posts: 332
Joined: April 5th, 2013, 10:55 am


Return to General Discussions

Who is online

Users browsing this forum: No registered users and 1 guest

cron