Hi
Having issues getting the Pocketerm to communicate with the Altair.
Connect the Pocketerm to Serial Port 1 set to 2SIO 9600 baud RTS/CTS all configurations
Original Cable was just as:-
25 Pin No. - 9 Pin No.
2 - 3, 3 - 2, 7 - 5
Which I thought should be enough connection.
Cable is now wired as:-
25 Pin No. - 9 Pin No.
2 - 3, 3 - 2, 4 - 7, 5 - 8, 6 - 6, 7 - 5, 8 - 1, 20 - 4, 22 - 9
But still same results.
Problem is:-
Configuration Monitor displays on Pocketerm but the keyboard does not work.
When I try and boot into CP/M from floppy no output on Pocketerm screen.
This all works fine if just connected to PC TeraTerm.
Tried connecting to serial port 2 with every serial options SIO and SIO2 with RTS/CTS 8N1 etc. no go at all. Disabled Print support on Port 2.
Checked inside box all connections are fine.
I have a cassette interface fitted which works fine using a Sony minidisc player!
The Pocketerm has been working fine with my N8VEM Zeta v2 SBC!
I was hoping to have my PC connected into Serial Port 1 and use Altair with the Pocketerm into Serial Port 2
What is the configuration that works?
Thanks